Yamaha 2014 MT-07 Service Manual page 180

• To route the front wheel sensor lead, refer to
"CABLE ROUTING" on page 2-41.
7. Measure:
• Distance "a"
(between the front wheel sensor rotor "1" and
front wheel sensor "2")
Out of specification → Check the wheel bear-
ing for looseness, and the front wheel sensor
and sensor rotor installation conditions
(warpage caused by overtorque, wrong in-
stallation direction, rotor decentering, LOC-
TITE® on the mounting surface of the rotor,
deformation caused by an impact during ser-
vice and caught foreign materials). If there is
any defective part, repair or replace the de-
fective part.
Distance "a" (between the front
wheel sensor rotor and front
wheel sensor)
0.5–1.3 mm (0.02–0.05 in)
TIP
Measure the distance between the front wheel
sensor rotor and front wheel sensor in several
places in one rotation of the front wheel. Do not
turn the front wheel while the thickness gauge is
installed. This may damage the front wheel sen-
sor rotor and the front wheel sensor.
Thickness gauge
90890-03180
Feeler gauge set
YU-26900-9
2
8. Install:
• Front wheel sensor lead holders "1"
• Front brake calipers
• Front brake hose/lead holders "2"
a
2
1
1
4-25
Front brake caliper bolt
40 Nm (4.0 m·kgf, 29 ft·lbf)
Front brake hose/lead holder bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
EWA13500
WARNING
Make sure the brake hose is routed properly.
TIP
• Make sure that the projection "a" on each front
wheel sensor lead holder contacts the front
fork.
• Install the front brake hose/lead holder so that
the projection "b" on the holder contacts the
stopper "c" on the front fork.
A
a
B
b
A. Right side
B. Left side
FRONT WHEEL
a
1
c
2