Yamaha 2014 MT-07 Service Manual page 228

• Fit the projection "b" on the bottom of the bolt
head into the slot "c" in the bolt hole in the
clutch lever holder.
• While squeezing the clutch lever, fit the projec-
tion "d" on the clutch switch into the slot "e" in
the clutch lever holder.
3
c
2
e
4
4. Install:
• Handlebar grip "1"
• Grip end (left) "2"
Grip end
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Side the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
1
a
b
2
d
LT
LT
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
a
2
▲ ▲▲▲ ▲ ▲▲▲ ▲
5. Install:
• Handlebar switch (left) "1"
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
1
a
6. Install:
• Throttle grip "1"
• Throttle cables
• Grip end (right)
▼▼▼
• Throttle cable housings "2"
TIP
• Align the projection "a" on the throttle cable
housing with the hole "b" in the handlebar.
4-73
HANDLEBAR
1
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
Handlebar switch screw (left)
2.0 Nm (0.20 m·kgf, 1.4 ft·lbf)
b
Grip end
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Throttle cable housing bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
▲ ▲▲▲ ▲ ▲▲▲