Yamaha 2014 MT-07 Service Manual page 89

1. Fuel tank breather hose
2. Fuel tank overflow hose
3. Intake solenoid coupler
4. Brake hose (hydraulic unit to left front brake
caliper)
5. Brake hose (front brake master cylinder to
hydraulic unit)
6. Clutch cable
7. Oil pressure switch lead
8. Oil pressure switch
9. O sensor
2
10. O sensor lead
2
11. Rear brake light switch lead
12. Rear brake light switch
13. O sensor coupler
2
14. Rear brake light switch coupler
15. Rear wheel sensor coupler
16. Oil pressure switch connector
17. Wire harness
18. Meter assembly cover
19. Coupler cover
20. Cylinder head breather hose
21. Intake solenoid vacuum hose (intake solenoid
to air filter case valve)
22. Intake solenoid vacuum hose (throttle body to
one-way valve)
23. Sub-wire harness
A. Route the clutch cable through the guide as
shown in the illustration.
B. Route the oil pressure switch lead through
the guide, and then secure the lead by
bending the guide around the lead.
C. Route the oil pressure switch lead to the
inside of the O sensor lead, and then secure
2
the leads by bending the guides around the
leads.
D. Fasten the rear brake light switch lead and O
sensor lead with the holder.
E. Connect the O sensor coupler, and then
2
insert the projection on the coupler into the
hole in the bracket.
F. Make sure that the wire harness is not
pinched between the pivot shaft protector
(right) and the frame.
G. Insert the projection on the wire harness
holder into the hole in the frame from the
inside of the frame.
H. Do not pinch the O
2
pivot shaft protector and the engine.
I. After connecting the meter assembly coupler,
install the coupler cover completely until it
contacts the meter assembly.
J. Less than 10 mm (0.39 in). Fasten the hose
protector of each hose with the holder.
sensor lead between the
K. Make sure that there is no slack in the fuel
tank breather hose or fuel tank overflow hose.
2
2-44
CABLE ROUTING