Removing The Side Covers; Removing The Tail Cover; Removing The Ecu (Engine Control Unit); Installing The Ecu (Engine Control Unit) - Yamaha Tenere 700 2020 Service Manual

EAS31264

REMOVING THE SIDE COVERS

The following procedure applies to both of the
side covers.
1. Remove:
• Side cover "1"
TIP
Remove the projections "a" on the side cover
from holes "b" on the tail cover, and then remove
the projections "c" from the grommets "d".
b
d
EAS33139

REMOVING THE TAIL COVER

1. Remove:
• Tail cover "1"
TIP
Unhook the projection "a" on the rear fender as-
sembly from the hole "b" on tail cover.
a
EAS31641

REMOVING THE ECU (engine control unit)

1. Disconnect:
• ECU coupler
TIP
While pushing the projection "a" and move the
lock lever "b" of the ECU coupler in the direction
of the arrow shown in the illustration to discon-
nect the coupler.
a
1
c
b
1
4-3
GENERAL CHASSIS (2)
a
EAS31642

INSTALLING THE ECU (engine control unit)

1. Connect:
• ECU coupler
TIP
Push the lock lever "a" of the ECU coupler in the
direction of the arrow shown in the illustration to
connect the coupler.
EAS33140

INSTALLING THE TAIL COVER

1. Install:
• Tail cover "1"
TIP
Fit the projection "a" on the rear fender assembly
into the hole "b" on the tail cover.
a
EAS31265

INSTALLING THE SIDE COVERS

The following procedure applies to both of the
side covers.
1. Install:
• Side cover "1"
b
a
b
1