Yamaha 2014 MT-07 Service Manual page 103

1. Brake hose (hydraulic unit to left front brake
caliper)
2. Front wheel sensor lead
3. Brake hose (left front brake caliper to right
front brake caliper)
4. Brake hose (front brake master cylinder to
hydraulic unit)
A. Make sure that there is no slack in the front
wheel sensor lead and that the lead is not
pinched between the headlight unit side cover
(right) and the brake hose (hydraulic unit to
left front brake caliper) in the area shown in
the illustration.
B. Fasten the front wheel sensor lead and brake
hose (hydraulic unit to left front brake caliper)
with the holder as shown in the illustration.
Position the holder 80–100 mm (3.15–3.94 in)
from the grommet on the hose and route the
lead over the hose.
C. Face the catch of the holder forward, and
then close the holder until three clicks or more
are heard.
D. Make sure that the holder contacts the end of
the hose protector on the brake hose.
E. Fasten the front wheel sensor lead and brake
hose (hydraulic unit to left front brake caliper)
with the holder as shown in the illustration.
Position the holder 30–50 mm (1.18–1.97 in)
from the grommet on the hose and route the
lead to the rear of the hose.
F. To front brake master cylinder
G. To hydraulic unit
H. Fasten the front wheel sensor lead and brake
hose (hydraulic unit to left front brake caliper)
with the holder as shown in the illustration.
Position the holder 15 mm (0.59 in) or less
from the grommet on the hose and route the
lead to the outside of the hose. Face the
catch of the holder inward, and then close the
holder until three clicks or more are heard.
2-58
CABLE ROUTING