Yamaha 2014 MT-07 Service Manual page 245

TIP
Face the holes "a" in the lower bracket cap rear-
ward.
2
1
a
3. Install:
• Lower bracket
• Cap nut "1"
Refer to "CHECKING AND ADJUSTING
THE STEERING HEAD" on page 3-19.
TIP
Before installing the cap nut, remove any grease
from the contact surfaces "a" between the cap
nut and the bearing cover and from the threads
"b" of the lower bracket and cap nut.
b
a
4. Install:
• Front brake hose holder bracket "1"
• Headlight bracket
• Front brake hose upper holder "2"
• Front brake hose lower holder "3"
Front brake hose holder bracket
bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
Front brake hose lower holder
bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Make sure that the front brake hose holder
bracket contacts the projection "a" on the lower
bracket.
• Make sure that the projection "b" on the front
brake hose lower holder fits into the hole in the
front brake hose upper holder.
1
4-90
STEERING HEAD
1
a
b
2
3