Removing The Front Fender Side Covers And Front Fork Legs; Disassembling The Front Fork Legs - Yamaha 2014 MT-07 Service Manual

EAS31110
REMOVING THE FRONT FENDER SIDE
COVERS AND FRONT FORK LEGS
The following procedure applies to both of the
front fender side covers and front fork legs.
1. Remove:
• Front fender side cover "1"
• Front fender "2"
• Front fender brackets
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the projection "a" on the cover from
the hole "b" in the front fender.
b. Slide the front fender side cover forward to re-
move the projections "c" on the cover from
the holes "d" in the front fender, and then re-
move the cover.
2
d
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
2. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that the
front wheel is elevated.
3. Loosen:
• Front fork cap bolt "1"
• Upper bracket pinch bolts (left and right) "2"
• Upper bracket pinch bolt (center) "3"
• Lower bracket pinch bolts "4"
2
1
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
b
a
c
1
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
2
1
3
▼▼▼
EWA13640
WARNING
Before loosening the upper and lower brack-
et pinch bolts, support the front fork leg.
EAS30207

DISASSEMBLING THE FRONT FORK LEGS

The following procedure applies to both of the
front fork legs.
1. Drain:
• Fork oil
TIP
Stroke the outer tube several times while drain-
ing the fork oil.
▲▲▲
2. Remove:
• Dust seal "1"
• Oil seal clip "2"
(with a flathead screwdriver)
ECA14180
NOTICE
Do not scratch the inner tube.
4-80
FRONT FORK
4