Yamaha 2014 MT-07 Service Manual page 115

1. Coolant reservoir hose
2. Radiator inlet hose
3. Thermostat housing
4. Oil cooler inlet hose
5. Coolant reservoir breather hose
6. Coolant reservoir
7. Coolant reservoir cap
8. Radiator
9. Radiator cap
10. AC magneto lead
11. Horn lead
A. Fasten the coolant reservoir hose to the
radiator inlet hose with the plastic locking tie.
Position the coolant reservoir hose directly
under the radiator inlet hose. Face the buckle
of the plastic locking tie inward with the end
pointing downward.
B. Align the white paint mark on the radiator inlet
hose with the projection on the thermostat
housing. Install the radiator inlet hose onto
the thermostat housing, making sure that the
hose contacts the projection on the housing.
C. Point the ends of the hose clamp outward.
D. Install the coolant reservoir hose onto the
coolant reservoir cap, making sure that the
hose contacts the cap.
E. Face the catch of the holder forward.
F. Position the clamp screw within the range
shown in the illustration.
G. 90°
H. Outward
I. Route the coolant reservoir breather hose to
the outside of the oil cooler inlet hose.
2-70
CABLE ROUTING