Yamaha 2014 MT-07 Service Manual page 188

TIP
• Install the rear wheel with the mark "a" on the
rear tire pointing in the direction of wheel rota-
tion.
• Align the projection "b" in the swingarm with the
slot "c" of the brake caliper bracket.
• Make sure that the arrow mark "d" on each
chain puller points upward.
• Make sure that the arrow mark "e" on each
swingarm end plate points upward.
a
3
e
6. Install:
• Rear brake caliper
1
c
b
2
d
• Rear brake caliper retaining bolt
• Rear brake caliper bolt
7. Fit the space "a" between the side plates of
the drive chain "1" onto the rib "b" on the drive
chain guide "2".
8. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-17.
Drive chain slack
51.0–56.0 mm (2.01–2.20 in)
9. Tighten:
• Wheel axle nut
• Rear brake caliper retaining bolt
• Rear brake caliper bolt
Wheel axle nut
105 Nm (10.5 m·kgf, 76 ft·lbf)
Rear brake caliper retaining bolt
27 Nm (2.7 m·kgf, 20 ft·lbf)
Rear brake caliper bolt
22 Nm (2.2 m·kgf, 16 ft·lbf)
LOCTITE®
EWA13500
WARNING
Make sure the brake hose is routed properly.
10.Install:
• Rear wheel sensor
Rear wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
ECA21080
NOTICE
Make sure there are no foreign materials in
the rear wheel sensor rotor and rear wheel
sensor. Foreign materials cause damage to
the rear wheel sensor rotor and rear wheel
sensor.
4-33
REAR WHEEL
1
a
2
b