Yamaha 2014 MT-07 Service Manual page 220

TIP
Do not allow any foreign materials to enter the
hydraulic unit assembly or the brake hoses
when installing the hydraulic unit assembly.
ECA21110
NOTICE
Do not remove the rubber plugs or bolts
(M10 × 1.25) installed in the brake hose union
bolt holes before installing the hydraulic unit
assembly.
2. Remove:
• Rubber plugs or bolts (M10 × 1.25)
3. Install:
• Brake hose (rear brake master cylinder to hy-
draulic unit) "1"
• Brake hose (front brake master cylinder to
hydraulic unit) "2"
• Brake hose (hydraulic unit to left front brake
caliper) "3"
• Brake hose (hydraulic unit to rear brake cali-
per) "4"
Front brake hose union bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
Rear brake hose union bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
ECA21120
NOTICE
If the brake hose union bolt does not turn
easily, replace the hydraulic unit assembly,
brake hoses, and related parts as a set.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Temporarily install the brake hoses as shown
in the illustration.
b. Position the brake hose (front brake master
cylinder to hydraulic unit) "2" so that its pro-
jection "a" contacts the brake hose (rear
brake master cylinder to hydraulic unit) "1",
and then temporarily tighten the union bolt for
the brake hose (front brake master cylinder to
hydraulic unit).
c. Temporarily tighten the union bolt for the
brake hose (rear brake master cylinder to hy-
draulic unit) "1".
TIP
Make sure that the pipe section "b" of the brake
hose (rear brake master cylinder to hydraulic
unit) does not contact the hydraulic unit.
d. Position the brake hose (hydraulic unit to left
front brake caliper) "3" so that its projection
"c" contacts the brake hose (front brake mas-
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
ABS (ANTI-LOCK BRAKE SYSTEM)
ter cylinder to hydraulic unit) "2", and then
temporarily tighten the union bolt for the
brake hose (hydraulic unit to left front brake
caliper).
e. Position the brake hose (hydraulic unit to rear
brake caliper) "4" so that its projection "d"
contacts the brake hose (rear brake master
cylinder to hydraulic unit) "1", and then tem-
porarily tighten the union bolt for the brake
hose (hydraulic unit to rear brake caliper).
f. Tighten the brake hose union bolts to specifi-
cation.
4
▲ ▲▲▲ ▲ ▲▲▲ ▲
4. Connect:
• ABS ECU coupler "1"
TIP
• Connect the ABS ECU coupler, and then push
the lock lever "a" of the coupler in the direction
of the arrow shown.
• Make sure that the ABS ECU coupler is con-
nected in the correct position as shown in illus-
tration "A".
▼▼▼
4-65
1
2
b
d
a
c
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
a
3
▲ ▲▲▲ ▲ ▲▲▲
1