Yamaha 2014 MT-07 Service Manual page 179

• Front brake discs
Front wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
Front brake disc bolt
18 Nm (1.8 m·kgf, 13 ft·lbf)
LOCTITE®
ECA21010
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and wheel
sensor bolts with new ones.
TIP
• Install the wheel sensor rotor with the stamped
mark "a" facing outward.
• Install each front brake disc so that the cham-
fered portions of the rivets "b" face outward.
• Tighten the brake disc bolts in stages and in a
crisscross pattern.
a
A
2. Check:
• Front brake discs
Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-41.
3. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
4. Install:
TIP
Install the front wheel with the mark "a" on the
front tire pointing in the direction of wheel rota-
tion.
5. Tighten:
ECA19760
NOTICE
Before tightening the wheel axle, push down
hard on the handlebars several times and
check if the front fork rebounds smoothly.
TIP
First, tighten the wheel axle, then the wheel axle
pinch bolt.
6. Install:
ECA21020
LT
NOTICE
b
Make sure there are no foreign materials in
the front wheel sensor rotor and front wheel
sensor. Foreign materials cause damage to
the front wheel sensor rotor and front wheel
sensor.
TIP
• When installing the front wheel sensor, check
4-24
• Collars
• Front wheel
• Front wheel axle
a
• Front wheel axle
• Front wheel axle pinch bolt
Front wheel axle
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
• Front wheel sensor
Front wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
the wheel sensor lead for twists.
FRONT WHEEL