Ink Switch Dog - Brother GT-3 Series Service Manual

6. Replacing Parts

6-1-34. Ink Switch Dog

Required Tool
・ Phillips screwdriver Plus
・ Flathead screwdriver
・ Radio Pliers
・ Gloves
When you replace the Ink Switch Dog, first remove the Ink Switch Dog Unit (A) in the photo below from the
printer and put them on the table for operation.
Pay attention for those small parts (e.g. springs).
(A)
There are three adjusted types of mounting Ink Switch Dog Unit (A) in the following photos, the relations
between the oval hole (1) and the Screw (2), Pattern 1: the Center type (left photo), Pattern2: the Left type
(center photo) and Pattern 3: the Right type (right photo).
Confirm before you unscrew, and be sure to fix them as they were.
Left type
Center type
Right type
(1)
(2)
Pattern 3
Pattern 1 Pattern 2
(Right type)
(Center type) (Left type)
GT-3 Series
226