Menu List - Brother GT-3 Series Service Manual

1-3-7-2. Menu List

Push either one of the OK Button, Up Button, Down Button and Back Button to go into the Menu.
Menu
Head Cleaning
Test Print
Daily Cleaning White
Print Data Load
Print Direction
Maintenance
Executes Head Cleaning of either one by one or of all four Print Heads.
See "7-2-2. Cleaning the Print Heads" in the Instruction Manual.
Normal: normal mis-firing
Powerful: After cleaning the Print Head nozzles, when normal head cleaning
does not work.
Prints to check mis-firing and print quality.
Nozzle Check CMYK / W: shows mis-firing
Standard Check CMYK / W: shows general print quality
Whiteness: confirms the white quality
Head Test CMYK / W: confirms which print head is broken
Flushes the " thinner and white-less" dull White Ink caused by sinking white
pigment. See "6-2-1. Daily Cleaning White for replacing dull White Ink" in the
Instruction Manual.
Reads a print data (AR3 file) in USB flash drive. The inside folder shows with [...].
Sets the print direction. This setting is prior to Printer Driver setting.
Auto： Default Bi-directional, Printer Driver setting is available.
Always Uni-Directional: always prints Uni-directionally.
Always Bi-Directional: always prints bi-directionally. See "7-2-4. Changing the
Print Direction" in the Instruction Manual.
Goes into the Maintenance submenu.
White Tube Cleaning:
Cleans the pigment in White Print Heads and Tubes. See "4-1-4. Cleaning the
Tubes and Print Heads (White/Color Tube Cleaning)".
Load White: Loads White Ink into the Tubes filled with Maintenance Solution
after White Tube Cleaning. See "4-1-4. Cleaning the Tubes and Print
Heads (White/Color Tube Cleaning)".
Initial Cleaning:
Loads ink into the empty new Tubes and Print Heads. CMYK ink is loaded
directly into Tubes. Maintenance Solution is required before White ink.
Maintenance Parts Exchange: See "6-1-2" to "6-1-7" in the Instruction Manual.
Reset CMYK Filter: Resets the warning after you replace K/C or M/Y Filter with
the new.
Nozzle Cleaning: Select this menu when you cannot solve mis-firing. See
"7-2-6. Cleaning the Print Head Nozzles" in the Instruction Manual.
CR Encoder Strip Cleaning:
See "5-1-5. Cleaning the Encoder Strip" or "6-1-7. Cleaning the Encoder
Strip" in the Instruction Manual.
Head Replacement:
See "6-1-38. Print Heads" or "7-2-7. Replacing the Print Head" in the
Instruction Manual.
Color Tube Cleaning:
See "4-1-4. Cleaning the Tubes and Print Heads (White/Color Tube
Cleaning)"
Log Copy to USB:
See "3-4. Getting Log File and Analysis".
Content
GT-3 Series
1. About GT-3 Series
9