Brother GT-3 Series Service Manual page 152

Assembling
1.
Mount the Origin Sensor to the Sensor Holder.
<Note> First hook the claw (1) and then hook the two claws (2).
(1)
2.
Connect the Harness: Platen Origin (3) to the Connector (4).
3.
Fix the Sensor Holder (5) with the one Screw (6).
<Note> Mount the Sensor Holder with fitting the two projecting points of the Sensor Holder (B) with the
two positioning holes (A) on the Guide Support Plate R.
(2)
(3)
(4)
(5)
(A)
(6)
GT-3 Series
6. Replacing Parts
(B)
143