Assembling / Disassembling Of The Maintenance Unit - Brother GT-3 Series Service Manual

6-1-16. Assembling / Disassembling of the Maintenance Unit

<Note>
A Maintenance Unit Check Gauge is required when installing the Maintenance Unit.
Cover the Print Head Nozzles with Print Head Protection Film not to make them dry.
Required Tools
・5 mm hexagonal wrench
・Phillips screwdriver
・Maintenance Unit Check Gauge (SB3169001 MNT CHECK GAUGE)
・Four Print Head Protection Films (SA6292001, 4 NOZZLE PROTECT FILMs)
・Maintenance Solution and Wash Liquid
A. Preparation
1.
Turn ON the printer.
2.
Select [ Maintenance ] > [ Maintenance Parts Exchange ] from the menu and press the OK button. The
Platen moves to its storage position, the Maintenance Unit Cap mechanism drops, and the Print Head
Carriage moves to the center position and stops.
3.
The message "Turn Off, Refer to instruction manual" appears. Turn OFF the printer and unplug the AC
Cord.
4.
Wash the Print Head Protection Films with either Maintenance Solution or Wash Liquid to keep them
clean and safe. Cover the cleaned Print Heads with the Print Head Protection Films not to make them dry.
<Note>
・ Touch the surface horizontally with the Clean Applicator as shown in the following image to make the
Nozzles clean and wipe softly the Nozzle Plate (1) with the Clean Applicator.
・ Use one Clean Applicator for one Print Head.
・ Wipe off the dirty ink on the sponge with clean and soft cloth. Wet with Wash Liquid and wipe off.
(1)
GT-3 Series
6. Replacing Parts
00161Y,0052Y
165