Brother GT-3 Series Service Manual page 176

5.
Remove the Flushing Plate (5).
(5)
6.
Pull out the Drain Tube from the Waste Ink Tank and prevent the Tube from draining, e.g. use a clip and
some cloth to cover the edge, and pull out the Maintenance Unit from the back.
C. Temporary assembling the Maintenance Unit to the GT-3 body
1.
Insert the Maintenance Unit from the back. Align the two positioning pins with the left/right sides of the
U-shaped grooves (1). It is easier to guide the position by inserting the M4 screws.
2.
Tighten the four Bolt Sockets temporarily to adjust the Maintenance Unit back and forth.
<Note> Pay attention that the Waste Ink Tube (2) should not be bent.
Flushing Sponge
(1)
(2)
GT-3 Series
6. Replacing Parts
Flushing Felt
スポンジ
フェルト
(1)
0067Ｙ
167