Brother GT-3 Series Service Manual page 169

6. Replacing Parts
Assembling
1.
Pass the Encoder Strip (5) into the groove (A) of the Encoder, and mount the Resin Rivet (8) on the left
hole, and hook the Spring (7) on the right hole.
Confirm the direction: the black (covered) area should be in the left bottom.
Insert the Resin Rivet (8) to the position of the brim (B), and the push the tip (C) by holding it with pliers.
Align the Encoder Strip (5) in the front (D) of the support plate when you hook the Spring (7).
<Note>
Take care not to give any damage to the Encoder Strip (5); it is OK if the support plate gets damaged.
(5)
160
(A)
(C)
(B)
(8)
GT-3 Series
(Following to the next page)