Brother GT-3 Series Service Manual page 131

6. Replacing Parts
Dissembling
1.
Remove the three screws (13) and the nine Truss screws (14), and then dismount the Cover PF (15) and
the Cover DL (16) together by moving forward.
2.
Remove the five screws (17) and one Truss screw (18), and then dismount the Cover DR (19) by moving
rightward.
3.
Remove the two screws (20) and three Truss screws (21), and then dismount the Cover Cartridge (22)
by moving leftward.
<Note> Pay attention to the Tubes not to bend in operation.
4.
Remove the Truss screw (23) and dismount the Cover PB (24) by pulling out upward.
5.
Remove the eight screws (25) and dismount the Cover DB (26).
Assembling
1.
Insert the Cover PF (15) and the Cover DL (16) together from the front side, and then fix them with the
three screws (13) and nine Truss screws (14).
2.
Insert the Cover DR (19) from the right, hook it on the Frame (A) and them fix it with the five screws (17)
and the Truss screw (18).
3.
Mount the Cover Cartridge (22) on the printer and fix it with the two screws (20) and the three Truss
screws (21).
<Note> Pay attention to the Tubes not to bend in operation.
4.
Hook the Cover DB (26) on the Frame (B) and then fix it with the eight screws (25).
Pass the Waste Ink Tube through the groove (C) of the Cover DB (26).
Hook it
5.
Hook the holes on the Cover PB (24) on the claws of the printer and fix it with the Truss screw (23).
122
Hook it
GT-3 Series
0184Y
0185Y