Brother GT-3 Series Service Manual page 158

8.
Fix the Shoulder Bar with the four Screws (3).
(3)
9.
Clean the surface of the Platen with a soft cloth damped with mild detergent and then wipe it off with a
soft and dry cloth.
10. Mount the Platen on the printer and fix it with the Clamp Lever.
11. Apply a new Platen Sheet on a completely dry surface of the Platen. Peel off the smaller part of the
coated paper. Position the Platen Sheet and apply it from the back position of the Platen, and go on little
by little by peeling off the bigger part of the coated paper.
<Note>
Put the Platen Sheet straight against the Platen without making creases.
12. Confirm the level of the Platen Top Plate. (Refer to "6-1-11. Leveling of the Platen Top Plate".)
(3)
(4)
GT-3 Series
6. Replacing Parts
0078Ｙ
149