Setting Up Gt-3 Series; Installing The Print Heads - Brother GT-3 Series Service Manual

4.
Place the spirit level (1) longitudinally on the Platen as shown below.
5.
Rotate the Adjusters (2) to adjust the levelness in the lateral direction by less than 1 mm/.
6.
Place the spirit level on the Platen in the lateral direction again to verify whether the printer is still level in
both directions.
If the levelness is not within 1 mm/m, repeat the steps 3 to 5.
7.
When the adjustment is complete, tighten the four Nuts for the Adjusters.

2-4. Setting up GT-3 Series

1.
Refer to the Uncrate Manual packed in the crate with the printer when you unpack and setup the
accessories.
2.
Confirm the following pints before you connect the AC cord.
・The Wiper Cleaners, Flushing Sponge / Flushing Felts and other Exchange Parts should be mounted
on the printer.
・The Waste Ink Tube should be mounted properly; straight, without touching the bottom of the Waste Ink
Tank*.
（*･･･Parts Code is in "2-1-4. Consumable Requirements and Options"）
・The Rear Cover (Cover PB) should be mounted.
・The space should be at least 30 cm in the front for Platen moving forward, at least 20 cm in the right for
air flow from the Exhaust Fan.
・The strap that fixes the Carriage should be removed.
3.
Connect the AC cord and the printer, and plug in. Turn ON the printer.

2-4-1. Installing the Print Heads

<Note>
・Print Heads are delicate and easy to damage, please handle with care.
・Do not mount/dismount the Print Heads on the Maintenance Unit; the surface of the Print Heads will hit the
edge of Wiper Cleaner and may cause serious damage. Select the menu from the Operation Panel or move
the Carriage over the Flushing Plate by hand.
* Be sure to remove the Wiper Cleaners and lower the Caps beforehand if you have to operate on the
Maintenance Unit.
(1)
GT-3 Series
2. Setting up GT-3 Series
0028N
19