Brother GT-3 Series Service Manual page 224

7. . Remove the Connector (8) of the Harness: Ink MNT from the Ink Switch PCB Assy (7). Remove the Connector (8) of the Harness: Ink MNT from the Ink Switch PCB Assy (7).
(8)
8. 8. Loosen the Tube Clamp D3 Supply that fixes the Needles and Tubes, and disconnect the Tubes. Cover Loosen the Tube Clamp D3 Supply that fixes the Needles and Tubes, and disconnect the Tubes. Cover
the Tubes and the connecting tip (9) of the Needle with some joint. the Tubes and the connecting tip (9) of the Needle with some joint.
9. 9. Remove the two Bolt Sockets (10). Remove the Bolt Socket (12) that supports Ink Cartridge Base Unit Remove the two Bolt Sockets (10). Remove the Bolt Socket (12) that supports Ink Cartridge Base Unit
(11). Loosen the Bolt Socket (13). (11). Loosen the Bolt Socket (13).
Lift up the Ink Cartridge Base and pull it out from the hook slot (hole) (14) and disassemble from the Lift up the Ink Cartridge Base and pull it out from the hook slot (hole) (14) and disassemble from the
printer. printer.
<Note> <Note>
The weight of the Ink Cartridge Base Unit plus eight Ink Cartridges will be approx. 10 kg. Handle with The weight of the Ink Cartridge Base Unit plus eight Ink Cartridges will be approx. 10 kg. Handle with
care. care.
10 kg
(11)
(7)
(10)
(12)
GT-3 Series
6. Replacing Parts
(7)
( 9)
Nut 8
Washer Plain 5 8
(13)
(14)
215