Cap Rubber - Brother GT-3 Series Service Manual

6. Replacing Parts

6-1-22. Cap Rubber

Required Tool
・Phillips screwdriver
Disassembling
1.
Turn ON the printer.
2.
Select [ Maintenance ] > [ Nozzle Cleaning ] from the menu and press the OK button.
The Platen moves to the rear, the Caps (1) are down and then the Carriage moves between the Flushing
Plate and the Platen.
3.
The message "Turn Off, Refer to instruction manual" appears. Turn OFF the printer.
4.
Open the Front Cover UB.
5.
Remove the Wiper Cleaner. (Refer to
6.
Move the Wiper Blade Assys to the both edges.
(3)
7.
Remove the Cap Rubber (1) from the Cap Rubber Holder (3).
Pay attention not to break the claws (4) of the Cap Rubber Holder.
190
"6-1-18.
(4)
Checking and Adjusting the Wiper Blade Assy".)
(2)
(1)
Cap Lifter Frame
(1)
GT-3 Series