Brother GT-3 Series Service Manual page 202

2.
Fix the Cleaner Sensor Holder B (4) with the Screw (5), with tightening torque 0.8 N·m.
(4)
3.
Fix the four Screws of the Cord Clamp (6) and connect the Connector (8).
(6)
(7)
(8)
(6)
(8)
4.
Mount the Wiper Blade Assys and the Wiper Cleaners.
5.
Mount the Maintenance Unit. (Refer to "6-1-16. Assembling / Disassembling of the Maintenance Unit". )
6.
Confirm the initial operation, which is OK with no Wiper errors occur.
(5)
(6)
(7)
GT-3 Series
6. Replacing Parts
(5)
(4)
Lift of the Harness must be
less than 13 mm
193