Program A Scanning Job - Pitney Bowes relay 3000 Operator's Manual

2 • Program a Job

Program a Scanning Job

Enable OMR Scanning
1. When prompted, press Change (+/-) to select one of the OMR on
settings. (Refer to the OMR Settings table included here.)
2. Press Next (►) to accept the selection and advance to the next
setting.
OMR Scanning Settings Table
Use the OMR functions that apply to your scanning job.
OMR Settings Table
OMR Settings
OMR off
OMR on
OMR + Sequence
OMR + Select feed
OMR + Select feed +
Sequence
OMR Offset on
OMR Offset + Sequence
OMR Offset + Select feed
OMR Offset + SF +
Sequence
NOTE: Available options depend on the scanning functionality of your inserter.
2-6
OMR scanning is turned off for this job
OMR scanning is enabled for this job with
standard OMR mark positioning.
OMR scanning + Wrap Around Sequence
scanning is enabled for this job, with standard
OMR mark positioning.
OMR scanning + Select Feed/Autobatch
scanning for this job, with standard OMR mark
positioning.
OMR scanning + Select Feed/Autobatch
+ Wrap Around Sequence scanning is
enabled for this job, with standard OMR mark
positioning.
OMR scanning is turned on for this job, with
offset OMR mark positioning.
OMR scanning + Wrap Around Sequence
scanning is enabled for this job, with offset
OMR mark positioning.
OMR scanning + Select Feed/Autobatch
scanning is enabled for this job, with offset
OMR mark positioning.
OMR scanning + Select Feed/Autobatch +
Wrap Around Sequence scanning for this job,
with offset OMR mark positioning.
Description
SV63140 Rev. A