Start And Stop The Inserter; Fill The Sealer - Pitney Bowes relay 3000 Operator's Manual

3 ● Run a Job

Start and Stop the Inserter

1. Press Start on the control to begin automatic operation.
2. The inserter runs until it runs out of material or you press the Stop.

Fill the Sealer

When the sealer unit needs
refilling, the Add Sealing Solution
icon flashes in the display.
When this happens, add E-Z Seal
Sealing Solution or water:
1. Open the sealer bottle cover
hinge located at the rear, right
side of the inserter and remove
the bottle.
2. Fill the bottle with solution or
water to the level indicated.
3. Place the sealer bottle in
position in the inserter and
close the cover.
NOTE: If the sealer unit was
completely empty, allow time
for the fresh solution or water to
soak through the sealer before
you resume operation. This helps
assure a good seal.
NOTE: We recommend Pitney
Bowes E-Z Seal to minimize algae
growth and scale build-up.
3-12
®
SV63140 Rev. A