Pitney Bowes relay 3000 Operator's Manual page 52

3 ● Run a Job
5. Take the stack of inserts and
aerate and fan it to ensure that
individual pieces are not stuck
together.
6. Shingle the inserts (as shown
here) and place them on the
feed deck.
Loading orientation can vary
depending on the inserts. As a
general rule, load inserts using the
orientation guidelines in the table
below.
7. Let the wedge (material prop)
slide down behind the stack to
support the inserts.
Orientation Table for Loading Inserts
Insert Type
Slip
Reply Envelope
Pre-Folded
Booklet
3-10
Orientation
Face up, bottom edge first
Face up, top edge first
Face up, closed edge first
Face up, bound edge first
SV63140 Rev. A