3 ● Run a Job
Verify the Inserter Has Power
1. Verify the power cord is
connected to the socket on the
back of the inserter.
2. Verify the power cord is
plugged into a power outlet
near the machine and is easily
accessible.
3. Turn the power switch ON.
Select a Job
When the machine is turned ON,
the control panel display shows the
last job run and the message Trial
Piece Required.
To select the job you wish to run:
1. Press the Job button until the
job you want displays, OR
press Default if you want to run
the inserter with your standard,
default job settings
NOTE: Only a PB Service
Representative can modify default
job settings.
2. Load material - refer to the
Loading Material section.
3. If material is already loaded,
press Trial Piece. The inserter
sets itself and runs a test piece
to check.
3-4
SV63140 Rev. A