Select Feed (Sf1, Sf2); Auto Batch; Wrap Around Sequence (Was1, Was2, Was3) - Pitney Bowes relay 3000 Operator's Manual

OMR Scanning • 4

Select Feed (SF1, SF2)

These marks are used to control the feed of material from the feeder
holding the supplementary sheets/inserts on a set-by-set basis. Therefore
you cannot use select feed on a single-station inserter.
Use Select Feed 1 marks are in the primary sheet feeder to select
material from the supplementary sheet feeder. For C- and double fold, the
primary feeder is sheet feeder 1. For Z- and single fold, the primary feeder
is sheet feeder 2.
Use Select Feed 2 marks in the primary sheet feeder to select material
from the insert feeder. For C- and double fold, the primary feeder is sheet
feeder 1. For Z- and single fold, the primary feeder is sheet feeder 2.

Auto Batch

This mark identifies the last set of a batch, when the batch function is
in use. It must appear on all sheets of the OMR set that requests this
function.

Wrap Around Sequence (WAS1, WAS2, WAS3)

This is a numbering system which uses a sequential binary coding. If a
page is missing or the set goes out of sequential order, the system stops
processing and declares an error.
Three wrap around sequence marks are used within the code. The use of
three binary digits allows a decimal count of 0 to 7. Pages are numbered
from 0 up to 7, and then back to 0 on a continuous cycle throughout the
print run.
SV63140 Rev.A 4-9