Pitney Bowes relay 3000 Operator's Manual page 89

Troubleshooting and Error Messages • 6
Message
PAPER SHORT
PAPER SHORT
CHECK STACKER
SET LEVER
STREAM FEED
STREAM FEED
CHECK STACKER
SYSTEM ERROR
POWER DOWN
TRAY EMPTY
SV63140 Rev. A
The inserter detected that the material used is too
short in length.
• Check the actual material length matches the
length displayed.
• If correct, request another trial piece.
The inserter detected that the material used is too
short in length.
• Check the actual material length matches the
length displayed.
• If correct, request another trial piece.
The manual feed lever is in the incorrect position
for the mode of running.
• Move the manual feed lever to the correct
position (left position: manual; right: automatic).
The inserter detected two sheets fed together from
the feed tray indicated.
• Remove the material from the inserter.
• Reload and restart the inserter.
The inserter detected two sheets fed together from
the feed tray indicated.
• Remove the stream feed from the stacker.
• Reload and restart the inserter.
A fault has been detected in the main software.
• Switch the inserter off and on and retry.
• If the problem persists, call for service.
The tray indicated has no material. Reload the tray
and press Start.
Action
6-11