Pitney Bowes relay 3000 Operator's Manual page 45

Run a Job
The operating activities outlined here assume that a job has already been
programmed into the Relay 3000 or 4000 inserter. (Programming a job is
typically a Supervisor function.)
Activities Operators perform with the touch screen to run a previously
programmed job:
• Verify the inserter has power
• Select a job
• Load material
• Adjust and load the sheet feeders
• Adjust and load the envelope feeders
• Adjust and load the insert feeders
• Run a trial piece
• Run the job
• Fill the sealer (if needed)
• Adjust the stacker (if needed)
Read the safety information in this guide before
connecting the inserter.
SV63140 Rev. A
3 ● Run a Job
3-3