Table of Contents
Advertisement
Envelope Inverter - Transports the envelope into the stacker
4
face up.
Drop Stacker or Output Device
5
Located at the exit of the inserter, this device collects finished
mailpieces. This device can be latched against the inserter when
not in use. Alternatively, a range of power stackers are available
which offer greater capacity than the standard drop stacker.
Fold Plate 1 and 2 - They create the desired fold in material fed
6
from the sheet feeder(s). The fold plates are automatically set
from the control panel.
Measuring Scale — The scale is located on the left side of the
7
inserter near the sheet feeders; used as an aid in measuring
material and envelopes.
Power Switch
8
Manual Advance Knob
9
the front, lower, left side of the inserter. Use it to turn the inserter
mechanisms by hand to help clear a material.
Side Guide Adjustment Knob
10
guides on the envelope feeder.
Envelope Feeder
11
where they are filled with material requested from the other
feeder(s).
Sheet Feeder 2
12
functions are similar to those of sheet feeder 1, but the manual
feed option is NOT available from this feeder.
Sheet Feeder 1
13
that requires folding.
In addition, you can set sheet feeder 1 to Manual Feed. In this
mode, you can run stapled sets of up to five sheets. The inserter
waits for you to feed each set by hand into sheet feeder 1 before
folding and inserting the set automatically.
SV63140 Rev. A
-
This switch turns the inserter on and off.
-
The knob is located under a cover on
-
Feeds envelopes into the inserting area
-
Feeds material that requires folding. Its
-
This feeder is intended for feeding material
System Overview • 1
(not shown in image) -
-
Use this knob to adjust the side
1-5
Advertisement
Table of Contents
Troubleshooting
