Scanning And Non-Scanning Jobs - Pitney Bowes relay 3000 Operator's Manual

2 • Program a Job

Scanning and Non-Scanning Jobs

If OMR scanning functionality is enabled on your system, operators
can toggle scanning on and off depending on the job type. If scanning
functionality is not available on your inserter, your job programming setup
will differ slightly.
Refer to the table below to review the steps that apply to your job type and
follow the step-by-step instructions provide in this section.
Scanning and Non-Scanning Job Sequence
Scanning Jobs
Enable scanning (OMR On or Off)
Set fold type
Set main (scanning) sheet feeder
Set select/supplementary sheet or
insert feeder
Set the sealer
Set paper length
Set fold A /fold B
Set envelope depth
Set envelope stop
Set batch counter
Confirm job setup
Run a trial piece
2-4
Non-Scanning Jobs
Disable scanning (OMR Off) if
available on your inserter. (Skip if you
inserter does not have scanning)
Set fold type
Set accumulation
Set first/main sheet feeder
Set second/supplementary sheet
feeder
Set insert feeder
Set mode type (insertion or fold)
Set the sealer
Set paper length
Set fold A /fold B
Set envelope depth
Set envelope stop
Set batch counter
Confirm job setup
Run a trial piece
SV63140 Rev. A