7 • Service Menu & Troubleshooting
7.2.2
set Default Job
This sets the Default Job 0 (Zero).
7.2.3
set 50/60Hz
To set the frequency of the Mains supply. Factory set.
7.2.4
serial Interface
•
Meter Interface used for online solutions
•
Event Logging- Used by Engineering to monitor OMR and Software processing
•
OMR Data Logging- Used by Engineering to monitor OMR and Software processing
7.2.5
View error codes
This allows you to view the last 10 Error Codes (E01 – E126).
7.2.6
set DDD
This sets the position of the reference point of the DDD.
Sheet feeders 1 and 2:
•
Leading Edge
•
Sample At Middle
•
Trail edge
Insert feeder:
•
Leading Edge
7.2.7
set service counter
This sets the software counter: For EIU use only.
7.2.8
set Out of Material
This setting allows the Out of Paper sensors to be switched on or off for the sheet feeders, envelope
feeder and the insert feeder.
7.2.9
set Nesting constant
This is the timing of the insert being fed into the second fold panel. Initially set by the factory.
•
DI425/SI3500 = 12
•
DI380/SI3300 = 12
7-2
SDT333A DI380/DI425/SI3300/SI3500 Service Manual