Pitney Bowes relay 3000 Operator's Manual page 40

2 • Program a Job
Run a Trial Piece
Run a trial piece to test the job settings.
1. Load material and press Trial Piece.
2. If you need to make changes to the settings based on the trial piece:
a. Press Setup.
b. Log in with Supervisor access level.
c. Press Prev (◄), Next (►) to scroll to the setting you wish to
modify.
d. Press Change (+/-) to scroll to the desired option.
3. Press Setup to accept the setting modification and return to run
mode. The inserter saves the job with the new settings.
4. Run another trial piece to test the modified settings.
NOTE: Any time you modify settings you must run a trial piece.
Incorrect Address Position - Adjust Fold Settings
When you run a trial piece, if the address is not in the correct position
refer to the Adjust Fold Settings table to help you fine tune your folds
settings.
Adjust Fold Settings Table
Fold Type
C - Letter Fold
Z - Accordion Fold
Single Fold
Double Fold
It is recommended the fold is only adjusted by 0.20 inches (5mm) each time.
2-22
Address Too Low
Decrease Fold A
Increase Fold A
Increase Fold A
Decrease Fold A
Address Too High
Increase Fold A and
increase Fold B by the
same amount.
Decrease Fold A and
increase Fold B by the
same amount
Decrease Fold A
Increase Fold A
SV63140 Rev. A