1 • System Overview
Control Panel Identification
Use the buttons on the system control panel to set up and run jobs. The
display screen shows the system status.
11
10
9
Clear Deck - Press to jog material through and out of the
1
inserter. Also use it to clear the inserter and make it ready for
automatic operation after a stoppage has occurred.
Trial Piece - Press to run a single test piece to check inserter
2
setup. You must run a trial piece before you begin automatic
operation using the Start button. If double detection is
enabled, the inserter sets itself automatically to run the trial
piece. The trial piece envelope will be unsealed and counted
as one item.
Delete - Press while in setup mode to delete a programmed
3
job from memory.
Setup - Press to enter the setup mode. This mode allows you
4
to program jobs into memory for instant recall using the Job
button.
Change + – - In setup mode, press to select options or set
5
values of inserter settings.
Prev ◄ ► Next - In setup mode, press to step backward or
6
forward through the various job settings.
1-6
1
2
8
7
SV63140 Rev. A
3
4
5
6