Pitney Bowes relay 3000 Operator's Manual page 30

2 • Program a Job
Set the Envelope Stop
NOTE: The stop has five positions numbered 1 to 5. Setting 3 is the standard
setting for normal weight paper with standard folds. A thinner/lighter insert requires
a lower setting and a thicker/heavier insert requires a higher setting.
1. Press Change (+/-) to scroll through the envelope stop positions.
2. Press Next (►) to accept the position and advance to the next setting.
Set the Batch Counter
The batch counter allows you to automatically process pre-defined
batches of finished mailpieces. When the batch is complete, the inserter
automatically stops.
NOTE: If the batch counter is not turned on, the display counter simply counts the
number of items processed until you press Reset Counter.
1. Press Start to begin processing the next batch.
2. Press Change (+/-) to toggle the batch mode to On or Off.
NOTE: If the batch counter is turned on, the inserter prompts for the batch
quantity. The default quantity is 50, but you may select any value up to 999 by
pressing Change (+/-).
3. Press Next (►) to accept the setting.
Confirm Job Setup
Job setup is now complete. Using the inserter model and icons, the touch
screen display shows all the selected job settings.
1. Review the job settings.
2. Press Prev (◄) to scroll back and change a setting.
3. Press Setup to accept the new settings and exit setup mode.
4. When setup changes are complete, the touch screen displays the new
job settings with the message Trial Piece Required.
5. Test the setup by running a trial piece.
NOTE: The inserter retains job settings until you change or delete them, even
when the power is disconnected. If you need to change the name of the job, refer
to "Change a Job Name" in the System Overview chapter of this guide.
2-12 SV63140 Rev. A