Connecting Polycom Vvx Expansion Modules To Your Phone - Polycom VVX 101 User Manual

Polycom VVX Business Media Phones User Guide
3 Wait until both the Power and LAN LEDs on the Wi-Fi adapter are solid green.
4 Make sure the computer gets the IP address.
5 Open your browser.
The NETGEAR WNCE2001 Wi-Fi adapter setup page is displayed automatically. Refer to the
Troubleshooting section of the
not see the WNCE2001 Wi-Fi Adapter set up page.
6 Follow the instructions on the setup page.
7 After completing the setup, disconnect the Ethernet and USB cables from your computer.
8 Connect the Ethernet and USB cables on the WNCE2001 to the VVX phone.
If your VVX phone doesn't have a USB port (VVX 300/310 or 400/410) or the USB port is disabled
(VVX 500, 600, or 1500), you can use the power adapter that comes with the Wi-Fi adapter to power
the unit.
Note: Wi-Fi Protected Setup
Wi-Fi Protected Setup (WPS) is a simple and secured way to connect a device to an existing network.
If you have a NETGEAR router, this feature is called Push 'N' Connect. Look for the
router to make sure the NETGEAR router supports WPS. For non-NETGEAR routers, refer to the
user manual to determine if the router supports WPS.
Connecting Polycom VVX Expansion Modules to Your
Phone
The Polycom VVX Expansion Modules are consoles you can connect to Polycom VVX Business Media
phones to add additional lines. VVX Expansion Modules enable you to handle large call volumes on a daily
basis and expand the functions of your phone.
VVX 101, 201, and 1500 phones do not support VVX Expansion Modules. Check with your system
administrator to find out if your phone is set up to support VVX Expansion Modules.
Polycom, Inc.
NETGEAR WNCE2001 User Guide if you open your browser and do
symbol on the
202