Right Side Cover (System Base) Removal (Model 6E4) - IBM pSeries 630 6C4 Service Manual

Right Side Cover (System Base) Removal (Model 6E4)

To remove the right side cover (system base), do the following:
1. Remove the bezel door as described in "Bezel Door Removal" on page 441.
2. Remove the front bezel as described in "Front Bezel Removal (Model 6E4)" on page 443.
3. Remove the top cap as described in "Top Cap Removal (Model 6E4)" on page 432.
4. Remove the operator panel as described in "Operator Panel Removal" on page 484.
5. Remove the back cover as described in "Back Cover Removal (Model 6E4)" on page 437.
6. Remove the outer service access cover as described in "Outer Side Cover Removal (Model 6E4)" on
page 435.
7. Remove the top cover as described in "Top Cover Removal (Model 6E4)" on page 433.
8. Remove the four retaining screws that secure the system chassis to the system base.
9. Use three people to lift the system up and off the alignment pins.
10. To remove the system base plate, lay the system onto its side and remove the four retaining screws.
1 Top Cap
2 Operator Panel EMC Bracket
3 Operator Panel
4 Operator Panel Bracket
5 Top Cover
6 Model 6E4
7 Bezel Door
8 Bezel
9 Rear Top Cover Mounting Bracket
10 Rear Cover
11 System Base Plate
12 Operator Panel Extension Cable
13 Right Side Cover (System Base)
Chapter 9. Removal and Replacement Procedures
439