Removing The Left-Side Cover (Tower Model) - IBM xSeries 240 81Y Hardware Maintenance Manual

Removing the left-side cover (tower model)

Before you begin:
Read "Safety information" on page 224.
Note
The illustrations in this book are similar to your server;
details might vary.
1
Cover-release latch
2
Cover
To remove the left-side cover of the tower model or
the top cover of the rack model:
1. If you are planning to install or remove any part other
than a hot-swap hard disk drive, hot-plug adapter,
hot-swap power supply, or hot-swap fan, turn off the
server and all attached devices and disconnect all
external cables and power cords (see "Preparing to
install options" on page 96).
2. Slide the cover-release lever 1 on the front of the
server to release the cover and slide the cover 2
toward the rear of the server about 25 mm (1 inch).
Move the top edge of the cover out from the server;
then, lift the cover off the server. Set the cover aside.
CP
U
VR
M
M EM
OR
PC I BU Y HD
D
S
A
B
NM
PO I
W SM
ER I
SU SE
1 PP RV
2 LY BU IC
S E PR
3 OC
FA ES
N NO SO
N RE R
DU
1 ND
2 AN
T
3
TE
M PE
RA
TU
RE
99
xSeries 240