Side Cover Removal; Removing The Rack Top Frame For Clearance Through Doorways - IBM eserver pSeries 690 Installation Manual

Side Cover Removal

1. Always remove the right side cover first.
2. Remove the (2) screws and washers inside the frame (part numbers 77G0599 and
1625437).
3. Remove the (3) screws at the top of the frame (part number 54G2882). The use of
a stepladder is recommended for this procedure.
4. With all the screws removed, rock the cover to the right from the top. There are
features built into the cover that lock it behind the left hand cover - and these
features must be clear before you can lift the cover from the frame. Tilting the top of
the cover away from the frame after the feature tabs have cleared the left cover
makes lifting the cover easier.
5. Use steps 2 and 3 to remove the the left side cover.
6. With all the screws removed from the cover, tilt the top of the cover away from the
frame and lift off.

Removing the Rack Top Frame for Clearance Through Doorways

The following steps describe removal of the rack top frame for clearance through
doorways.
1. Use the jack screws to stabilize and lift the rack off the floor, as follows:
a. Loosen the jam nut on each leveling foot by turning the nut counter-clockwise.
b. Rotate each leveling foot downward until it contacts the surface on which the
c. Adjust the leveling feet downward as needed until the rack is level. When the
Eserver pSeries 690 Installation Guide
100
4 Part Number 44P0126 Rear Latch
Part Number 54G2882 Screw
5 Part Number 44P0126 Right Cover
Part Number 54G2882 Screw
6 Part Number 11P3600 Left Cover
Part Number 44P0125 Screw
7 Part Number 44P0105 Front Cover
rack is placed.
rack is level, tighten the jam nuts against the base by turning the nut clockwise.
12 Part Number 05N6585 J Bracket
Part Number 2665528 Screw, Side
Cover
13 Part Number 05N6585 J Bracket
Part Number 2665528 Screw
14 Part Number 44P0126 Right Cover
Part Number 54G2882 Screw
15 Part Number 44P0125 Left Cover
Part Number 54G2882 Screw