Adding Or Replacing A Processor Card - IBM pSeries 630 6C4 Service Manual

Model 6E4 Processor Card
1 Model 6E4
2 Media Device Support Shelf
3 Media Carrier Trays
4 Optional Media Device (for example:
Diskette Drive or Tape Drive)
5 IDE CD-ROM Drive
6 Front Bezel
7 Bezel Door
8 Processor Filler

Adding or Replacing a Processor Card

Notes:
1. Adding an additional processor card or installing a new processor card into your system may require
the updating of the system firmware.
2. Before handling any card, board, or memory DIMM, touch any metal surface of the chassis with one
hand to minimize static electricity discharge. Refer to "Handling Static-Sensitive Devices" on page 423.
3. If your system is configured with one processor card, place the card into location U0.1-P1-C1 on the
CEC backplane. The remaining processor connector must have the processor filler panel in place. The
filler panel protects the connector located on the CEC backplane from dust or damage and assists in
airflow and cooling.
490 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
9 Service Access Cover
10 Outer Side Cover
11 Processor Access Cover
12 Processor Assembly Lifting and
Release Handles
13 Processor Card
14 Processor Assembly
15 Memory DIMMs