IBM pSeries 630 6C4 Service Manual page 194

Checkpoint
E1F9
E1FA
E1FB
E1FC
E1FD
E1FE
E1FF
E20F
E440
E441
E442
E443
174 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
Description
Building boot device list for fibre-channel
adapters. (The location of the SAN adapter
being scanned is also displayed.)
Building boot device list for SCSI adapters.
(The device ID and the device LUN being
scanned are also displayed.)
Scan SCSI bus for attached devices
Building boot device list for SSA adapters.
(The location code of the SSA adapter
being scanned is also displayed.)
The operator panel alternates between the
code E1FD and another Exxx code, where
Exxx is the point at which the error
occurred.
Building boot device list for fibre-channel
adapters. (The WWPN of the SAN adapter
being scanned is also displayed.)
Building boot device list for fibre-channel
adapters. (The WWPN of the SAN adapter
being scanned is also displayed.)
System firmware has exited to open
firmware prompt
Validate NVRAM, initialize partitions as
needed
Generate /options node NVRAM
configuration variable properties
Validate NVRAM partitions
Generate NVRAM configuration variable
dictionary words
Action/
Possible Failing FRU
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 124.
Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 124.
Go to "MAP 1542: I/O Problem Isolation" on
page 127.
1. If a location code is available, follow the
actions listed for error code 21A0 00xx.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 124.
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 124.
Go to "MAP 1542: I/O Problem Isolation" on
page 127.
1. Replace the CEC backplane,
Location: U0.1-P1.
2. Call service support.
1. Check for system firmware updates.
2. Replace the CEC backplane,
Location: U0.1-P1.
3. Call service support.
1. Check for system firmware updates.
2. Replace the CEC backplane,
Location: U0.1-P1.
3. Call service support.
1. Check for system firmware updates.
2. Replace the CEC backplane,
Location: U0.1-P1.
3. Call service support.
Suspect a system firmware problem if
problem persists. If a system firmware
update is available, install it.