Right Side Cover (System Base) Replacement (Model 6E4) - IBM pSeries 630 6C4 Service Manual

Right Side Cover (System Base) Replacement (Model 6E4)

To replace the right side cover (system base), do the following:
1. Ensure that the system base plate is secured to the system chassis. If the system base plate has not
been secured to the system chassis, lay the system chassis onto its side and secure the system base
plate with four retaining screws.
2. Using three people, lift the system up and seat the system chassis and the attached mounting plate
over the two alignment pins. The alignment pins are located at each end of the system base.
3. Using four retaining screws, secure the system chassis to the system base .
4. Replace the top cover as described in "Top Cover Replacement (Model 6E4)" on page 434.
5. Replace the outer side cover as described in "Outer Side Cover Replacement (Model 6E4)" on
page 435.
6. Replace the back cover as described in "Back Cover Replacement (Model 6E4)" on page 438.
7. Replace the top cap as described in "Top Cap Replacement (Model 6E4)" on page 432.
8. Replace the operator panel as described in "Operator Panel Replacement" on page 485.
9. Replace the front bezel as described in "Front Bezel Replacement (Model 6E4)" on page 443.
10. Replace the bezel door as described in "Bezel Door Replacement" on page 441.
440 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide