Removing the left-side cover (tower model)
Note: To remove or install a hot-swap hard disk drive or hot-swap power supply,
it is not necessary to remove the cover.
1
Cover release lever
2
Left-side cover
To remove the left-side cover of the tower model:
1. Review the information in "Before you begin" on page 47.
2. If you are planning to install or remove any part other than a hot-swap hard
disk drive or hot-swap power supply, turn off the server and all attached
devices and disconnect all external cables and power cords.
3. Slide the cover-release lever on the front of the server to release the cover; then,
slide the cover toward the rear of the server about 25 mm (1 inch). Move the
top edge of the cover out from the server; then, lift the cover off the server. Set
the cover aside.
Attention:
on the server. Operating the server for extended periods of time (over 30
minutes) with the cover removed might damage server components.
Removing the cover (rack model)
Note: To remove or install a hot-swap hard disk drive or hot-swap power supply,
it is not necessary to remove the cover.
For proper cooling and airflow, replace the cover before turning
49
Installing options