IBM pSeries 630 6C4 Service Manual page 328

Table 5. Service Processor Error Codes. (continued)
Error Code Description
406F 0C10 Processor 0 configuration error: VPD mismatch
for processor card 0. (Service processor code
problem.)
406F 0C11 Processor 1 configuration error: VPD mismatch
for processor card 1. (Service processor code
problem.)
406F 0CA5 Invalid system configuration
406F 0CA6 No usable memory left in the system. The
system must be rebooted.
406F 0CA9 Incorrect/incompatible memory DIMMs are
installed.
406F 0CAA System memory exceeds the limit for this
system type and model.
406F 0EA0 MOPS service processor code error.
406F 0EA1 Operating system code on main processor
406F 0EA2 PRD code on service processor error.
406F 0EA4 The service processor detected a problem, but
was unable to isolate the source.
406F 0EAF Service processor code and system type are
unknown
406F 0EB0 JTAG problem
406F 0EB1 Attention line 0 stuck fault
406F 0EB2 Attention line 1 stuck fault
406F 0EB3 Attention line 2 stuck fault
406F 0EB4 Attention line 3 stuck fault
406F 0EB5 Attention line 4 stuck fault
308 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
Action/
Possible Failing FRU
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check that the processor cards and memory
DIMMs are properly installed and configured.
2. If there are any FRUs listed in the service
processor error log entry, replace them one
at a time.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
Go to "MAP 1240: Memory Problem Resolution"
on page 73.
Check that the memory DIMMs are properly
configured, and are the right type for the system.
Remove the memory DIMMs until the memory
does not exceed the limit for this system type
and model.
1. Check for system firmware updates.
2. Call service support.
1. Check for operating system code updates.
2. If there are other symptoms, go (one
symptom at a time) to the "Quick Entry MAP"
on page 63 and follow the instructions.
3. Call service support.
1. Check for system firmware updates.
2. Call service support.
Contact next level of support.
1. Check for system firmware updates.
2. Call service support.
Go to "MAP 1541: JTAG Problem Isolation" on
page 126.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.
Go to "MAP 1540: Problem Isolation Procedures"
on page 124.