IBM pSeries 630 6C4 Service Manual page 212

Checkpoint
E570
E571
E572
E57F
E580
192 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
Description
Initialize the PCI-ISA bridge chip
Initialize the integrated Ethernet (if present) Replace the device specified by the
Initialize the integrated SCSI
End of RIO interface chip initialization
Begin initializing the EADS module.
Action/
Possible Failing FRU
Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
Replace the device specified by the
location code.
If the device specified by the location code
is the RIO riser card in an I/O subsystem
(location: U0.dd-P1.1), and replacing it
does not resolve the problem, replace the
I/O backplane (location: U0.dd-P1) in the
same I/O subsystem.
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 124.
1. Check for system firmware updates.
2. Replace the I/O subsystem's RIO riser
card (location: U0.dd-P1.1) specified by
the location code.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
specified by the location code.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 127.