IBM pSeries 630 6C4 Service Manual page 187

Checkpoint
B0FA
B0FF
Notes:
1. If the system fails to progress after this checkpoint is put in the display, do the following:
a. Activate the service processor pinhole reset switch on the system's operator panel.
b. If the hang repeats, check with service support to see if there is a firmware update that fixes the
problem.
c. If not, or the update does not fix the problem, replace the CEC backplane, location: U0.1-P1.
d. If this procedure does not fix the problem, call service support.
2. If the system fails to progress after this checkpoint is put in the operator display, do the following:
a. Activate the service processor pinhole reset switch on the system's operator panel.
b. Reboot the system in slow mode. (Slow/fast IPL is set using a service processor menu.) If the
hang repeats, check with service support to see if there is a system firmware update that fixes this
problem.
c. If not, or the update does not fix the problem, call service support.
3. Recovery mode flash update has failed. Do the following:
a. Activate the service processor pinhole reset switch on the system's operator panel and try the
recovery mode flash update again.
b. If the system hangs again, make a new set of firmware update diskettes, using new, blank
diskettes. Retry the flash update with the new diskettes.
c. If the same hang occurs with the new diskettes, replace the following FRUs one at a time in this
order:
1) Diskette drive
2) CEC backplane, location: U0.1-P1.
d. If this procedure does not fix the problem, call service support.
4. The service processor was unable to configure the modem(s) attached to the serial port(s) on the CEC
backplane (a problem with the modem attached to the HMC is not indicated). Do the following:
a. Check the modem, modem cable, and serial port for loose or unconnected cables. Reset the
service processor using the pinhole reset switch on the system's operator panel.
b. If the hang repeats, check with service support to see if there is a firmware update that fixes the
problem.
c. If there is not, or the update does not fix the problem, replace the following FRUs, one at a time, in
the following order:
1) Modem cable
2) Modem
d. If this procedure does not fix the problem, call service support.
Description
Delayed power-off acknowledged
Power-off requested program executing
Action/
Possible Failing FRU
See note 1.
See note 1.
Chapter 4. Checkpoints
167