IBM pSeries 630 6C4 Service Manual page 594

7. Finger-tighten a second retaining screw through the top screw hole of the latch bracket. After the
latch bracket is in place, ensure that both screws are finger-tight.
Attention: Do not tighten any of the screws more than finger-tight until instructed to do so.
Tightening the screws prevents the rails from self-aligning when the system drawer is attached.
8. Go to the rear of the rack.
9. Loosen, but do not remove, the six retaining screws that secure the rail-length adjusting plate to the
rail.
Note: The rail-length adjusting plate should not move freely when loosened.
10. Facing the rear of the rack, ensure that the right rail's two alignment pins are positioned in the correct
EIA unit's holes. Use two rack-retaining screws to attach the rail brackets to the rack flanges.
Finger-tighten both screws.
574 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
1 Front Slide Rail Alignment Pin
2 Retaining Screws
3 Latch Bracket
1 Rail-Length Adjusting Plate
2 Retaining Screws for Rail-Length Adjusting Plate