Multicast Policies; Ipv4 Multicast Policies - Dell S6000–ON Configuration Manual

Protocol Ethernet Address
RIP 01:00:5e:00:00:09
NTP 01:00:5e:00:01:01
VRRP 01:00:5e:00:00:12
PIM-SM 01:00:5e:00:00:0d
• The Dell Networking OS implementation of MTRACE is in accordance with IETF draft draft-fenner-
traceroute-ipm.
• Multicast is not supported on secondary IP addresses.
• Egress L3 ACL is not applied to multicast data traffic if you enable multicast routing.

Multicast Policies

The Dell Networking OS supports multicast features for IPv4.

IPv4 Multicast Policies

The following sections describe IPv4 multicast policies.
• Limiting the Number of Multicast Routes
• Preventing a Host from Joining a Group
• Preventing a PIM Router from Forming an Adjacency
• Preventing a Source from Registering with the RP
• Preventing a PIM Router from Processing a Join
Limiting the Number of Multicast Routes
When the total number of multicast routes on a system limit is reached, the Dell Networking OS does not
process any IGMP or multicast listener discovery protocol (MLD) joins to PIM — though it still processes
leave messages — until the number of entries decreases below 95% of the limit.
When the limit falls below 95% after hitting the maximum, the system begins relearning route entries
through IGMP, MLD, and MSDP.
• If the limit is increased after it is reached, subsequent join requests are accepted. In this case, increase
the limit by at least 10% for IGMP and MLD to resume.
• If the limit is decreased after it is reached, Dell Networking OS does not clear the existing sessions.
Entries are cleared after a timeout (you may also clear entries using the clear ip mroute
command).
NOTE: Dell Networking OS waits at least 30 seconds between stopping and starting IGMP join
processing. You may experience this delay when manipulating the limit after it is reached.
When the multicast route limit is reached, Dell Networking OS displays the following:
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB limit reached. No new
routes will
be learnt until TIB level falls below low watermark.
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB below low watermark.
Route learning
will begin.
To limit the number of multicast routes, use the following command.
594
Multicast Features