Assigning Area Id On An Interface; Assigning Ospfv3 Process Id And Router Id Globally - Dell S6000–ON Configuration Manual

Hide thumbs Also See for S6000–ON:

Table of Contents

The format is A:B:C::F/128.

Bring up the interface.

CONF-INT-type slot/port mode

Assigning Area ID on an Interface

To assign the OSPFv3 process to an interface, use the following command.

The ipv6 ospf area command enables OSPFv3 on an interface and places the interface in the

specified area. Additionally, the command creates the OSPFv3 process with ID on the router. OSPFv2

requires two commands to accomplish the same tasks — the router ospf command to create the

OSPF process, then the network area command to enable OSPFv2 on an interface.

NOTE: The OSPFv2 network area command enables OSPFv2 on multiple interfaces with the single

command. Use the OSPFv3 ipv6 ospf area command on each interface that runs OSPFv3.

Assign the OSPFv3 process and an OSPFv3 area to this interface.

CONF-INT-type slot/port mode

ipv6 ospf process-id area area-id

– process-id: the process ID number assigned.

– area-id: the area ID for this interface.

To assign, disable, or reset OSPFv3 globally, use the following commands.

Enable the OSPFv3 process globally and enter OSPFv3 mode.

CONFIGURATION mode

ipv6 router ospf {process ID}

The range is from 0 to 65535.

Assign the router ID for this OSPFv3 process.

CONF-IPV6-ROUTER-OSPF mode

router-id {number}

– number: the IPv4 address.

The format is A.B.C.D.

NOTE: Enter the router-id for an OSPFv3 router as an IPv4 IP address.

Disable OSPF.

CONFIGURATION mode

no ipv6 router ospf process-id

Reset the OSPFv3 process.

EXEC Privilege mode

clear ipv6 ospf process

Open Shortest Path First (OSPFv2 and OSPFv3)